The 4wd Eddy Braked Synchronous Belt driven Rolling Road installed in our workshops has full data logging facilities including wide band lambda with EGT monitor and allows cars and 4×4 vehicles to run true with no abs/traction systems disabled for accurate analysis, the dynometer used is the same model as used by Kleeman Mercedes, a world renowned tuning company , chosen for its accuracy and specification, especially in regard to new XDrive / Quattro vehicles which it runs without electronic calculations required by lesser dynos, improving accuracy . Its essential to ensure your vehicle is actually tuned on a “rolling road” and not offered a suitcase printout or “guesstimate” as some cheap generic mappers offer,with wild power figures claimed and no actual proof to back it up , and more importantly avoid your car being driven at high speed on the public highway “Live logging on public roads” with your vehicle being driven hard while a laptop logs on a main road.
Power Runs /Data Logging/live mapping….
The tuning process includes a Pre test run and diagnostic / Data aquisition , which enables us to gather the essential info required to custom tune your vehicle . The subsequent runs will involove live custom alteration of paramaters , such as Boost , fuel , Ingnition timing, torque limiters (application dependant)etc . The dyno enables us to simulate real driving conditions and load condtions via the readout linked to the eddy brake system, which can run up to 2500hp in state, which means a more accurate tuning platform than flash and dash tunes we see , typically with poor figures or/and potentially damaging map alterations.
Our advanced floor anchor /tethering system is able to cope with the most powerful cars to well over 1500hp ,and give accurate measurement for power and torque, while being safely secured at all times.
Before presenting for a DYNO run or Custom Tune/Dyno please ensure the following is carried out as we may refuse to run ,unless we are satisfied these checks have been done and the car meets our requirements .
The following conditions must be met and the vehicle checked by you the customer or his representative prior to your visit unless agreed beforehand by us-
- At least quarter tank of fuel on presenting the vehicle for tuning .
- Check oil and coolant levels prior to delivering into our care(owner /drivers responsibility)
- Make sure your tyres are safe to operate which can be in excess of speeds over 100 mph( We will refuse to run if deemed unsafe) .
- Drive train components must be for purpose without faulty/worn parts.
- Make sure your car is free of any oil, fuel or coolant leaks.
We reserve the right to refuse any vehicle we deem unfit to run .
The Waiver form must be signed prior to running and any vehicle entering the Dynometer,and is done so under the clear understanding that the owner//keeper or authorised person/s is running any vehicle under his / her care at his/her “own risk” at all times.